Spring Steel Railway Elastic Blade for Rail Fastening System Factory
Anyang Railway Equipment Co., Ltd(AT) is the manufacturer and supplier of CJ-2 Elastic blade fastening systems for Tren Maya Railway in Mexico.
The Elastic plate fastening system is elastic, direct. It has been designed to replace the RN elastic fastening that has been used since the RS type concrete sleeper began to be used, in RENFE, and to improve the P-2 fastening currently used, whose conception is the same. As a replacement for the RN, it solves the problems presented by the track assembled with the set consisting of the RS sleeper and the RN fastening, especially with regard to the electrical insulation between its two threads and the conservation of its width. It fully resolves the first one, even in unfavorable weather conditions, and almost completely cancels the variation in track width caused by the RN clamping, although of course it cannot have the same effect on the width variation caused by the rotation of the heads of the sleepers, as a consequence of their seats and the lack of rigidity of the metal brace that joins them. As an improvement to the P-2 fastening, it prevents eventual contact of the metal plate with the plastic part by interposing support steps on the upper face of the part. In this way, the plate will not transmit all the vertical forces to the plastic part. It also presents greater resistance to lateral forces than the old P-2 fastening system.
Anyang Railway Equipment Co., Ltd(AT) is the manufacturer and supplier of CJ-2 Spring Blade fastening systems for Tren Maya Railway in Mexico.
| CJ-2 Spring Blade Fastening System( CJ-2 Fastener System) | ||
| Item | Material | QTY |
| T- Bolt | SAE1045/45# | 2 |
| Flat Washer | ASTM A36 | 2 |
| Nut | ML08Al | 2 |
| Spring Blade(Elastic Plate) | AISI 5145 | 2 |
| Rail Pad | HDPE/TPEE | 1 |
| No.6 Guide Plate | PA6-GF30 | 1 |
| No.8 Guide Plate | PA6-GF30 | 1 |
| Insulating Washer | PA6-GF30 | 2 |
MATERIAL- AISI 5145 / 60SI2MN/65Mn
Requirement: Testing standard ASTM A370-10
Performance after annealing
|
Description |
Requirement | |
|
Hardness |
39-45 | HRC |
| Tensile Strength | ≥1274(130) | MPA(KG/MM2) |
| Yield Strength | ≥1176(120) | MPA(KG/MM2) |
| Elongation | 6 |
% |
| Min. Elasticity | 4 |
% |
Fatigue Test Requirement: Testing standard AREMA4.9.1.3 ARTICLE 4.9.1.11 SECTION 2.6 FASTENER 2.6.3 TEST:5C (BS EN 13146-4:2012)
